General Information
SPY is the smallest PIR detector available, and is suitable for any application where unobtrusive detection is required.

Residential, Commercial and Museums
Wall or ceiling-mounted (flush-fitted)
Covert installations

Superior RF protection
Pulse counter (on models 2, 3, 4)
Miniature size – 19 x 70 mm (3/4 x 2-3/4 in)
Flush mounts into a 22 mm (7/8 in) hole
Special request-to-exit version available for access control



Detection Patterns:
SPY 1 Long Range; narrow angle with coverage area of 11m x 17  (35 ft x 17 )
SPY 2 Medium Angle; 3 double beams in a single detection layer with coverage area of 8 m x 50  (25 ft x 50 )
SPY 3 Wide Angle; 6 double beams in a single detection layer with coverage area of 8 m x 100  (25 ft x 100 )
SPY 4 Solid Curtain; with coverage area of 2 x 4 m (6 x 12 ft)

Voltage: 10 to 14 VDC. Current: 12.5mA
Relay Output: Normally Closed (fail-safe) contacts, 18-ohm resistor in series with contacts. Rating – 0.1A resistive/24 VDC. Alarm Period: 2-10 seconds
Pulse Counter: Models 2, 3 and 4. Factory set to 2 pulses
Detector: Dual-element, low-noise pyroelectric detector
MOUNTING: SPY PIRs can be installed in a wall or ceiling and are available with both a collar and a front or rear mounting plate, depending on the model.

Operating Temperature: 0 C to 50 C (32 F to 122 F)
Storage Temperature: -20 C to 60 C (-4 F to 140 F)
RFI Protection: Greater than 10 V/M up to 1000 MHz

Dimensions: Diameter: 19 mm (3/4 in) x Length: 70 mm (2-3/4 in)
Weight: 30 g (1.1oz)
Color: White

SCS Small collar for in-wall or ceiling mounting
SCL Large collar for in-wall, ceiling or behind-the-wall mounting. Both SCS and SCL are supplied with the SPY 1, SPY 2 and SPY 4
SCL is permanently mounted on SPY 3
Other Available Models


Rate this page